1. <track id="lf6qx"></track><track id="lf6qx"></track>
        <tbody id="lf6qx"></tbody>
      2. <bdo id="lf6qx"><optgroup id="lf6qx"></optgroup></bdo>
      3. <track id="lf6qx"></track>
        <bdo id="lf6qx"></bdo>
        Technical support
        Technical support Current position:HomeTechnical supportTechnical support

        Installation and use of common coupling

        Release time:2016-04-18
        1 rigid coupling
        1.1. flange coupling
        1.1.1 common types:
        2 (a) to (b) in the non tenon and tenon
        (c) with protective edge
        1.1.2 installation and maintenance requirements:
        The coupling drive machine, coupling centering deviation of two shafts and couplings end clearance, technical documents should meet the requirements of the machine. If there is no requirement, the following requirements shall be:
        Two coupling end should be in close contact, the centering deviation of two shafts: radial displacement should be less than 0.03 mm, the axial tilt should be less than 0.05 / 1000.
        1.2. other rigid couplings
        1.2.1 common types:
        Sleeve coupling, shell coupling, tight coupling shell coupling, flange shell coupling and so on.
        1.2.2 installation and maintenance requirements:
        The coupling drive machine, coupling centering deviation of two shafts and couplings end clearance, technical documents should meet the requirements of the machine. If there is no requirement, the following requirements shall be:
        Two coupling end should be in close contact, the centering deviation of two shafts: radial displacement should be less than 0.03 mm, the axial tilt should be less than 0.05 / 1000.
        2 flexible coupling
        2.1. slider coupling:
        2.1.1. common types:
        (a) structure diagram
        Cross slider coupling, sliding block coupling, etc..
        2.1.2. installation and maintenance requirements:
        The coupling drive machine, coupling centering deviation of two shafts and couplings end clearance, technical documents should meet the requirements of the machine. If there is no requirement, the following requirements shall be:
        Slider coupling axis radial relative displacement is not greater than 0.01d+0.25
        Copyright @ Harmony machinery equipment(shanghai)CO,.LTD., any enterprise and individual has no right to steal, once discovered shall be investigated for legal responsibility. 沪ICP备16020975号-1 Tel:021-69105768 (69105786) Fax:021-69105723
        返回
        顶部